MICRO ACTIVE BRAKE WITH WIRING - Professionally designed and manufactured active motor brake mosfet with 500 mm long wires on each side for airsoft electric guns (AEG) - Very small device size - fits almost anywhere - four high-quality 1.5qmm (AWG16) power wires covered with silicone insulation and two 0.25qmm (AWG24) signal wires - If you want to use your own wires, choose the device without wiring. - The active pause uses excess energy from the motor to stop it. The braking effect is most powerful with a high torgue motor - In weapons with a very high rate of fire (ROF) the active brake resolves more shots in semi mode - in semi-fire mode the piston is partially unstretched, the spring is fully released, the parts in the mechabox are not under stress and the nozzle blocks the jump chamber to a greater extent (depends on the ROF) - in auto fire mode the piston stops in a random position due to the design of the mechabox. But this stop is much faster with active brake - The active brake increases the firing speed of the gun and the battery stays longer - no sparks on the switch contacts - specified for common batteries: Ni-xx 8.4 - 12V, lipol 7.4 - 11.1V - Designed for M130 spring and ROF 25bb/s. For higher load, use active brake or extreme variant of this device - Easy to understand 6-wire connection - Device dimensions 29x11x8mm - coated with paint, which protects the device from water - in the package is shrink-wrap on the device and installation manual in English.